Shop
ADHESIVE REMOVER/ SCALER
The Adhesive with Scaler is a multi-purpose orthodontic instrument it is designed double- ended instrument. One side is for adhesive remover with sharp flat blade is held at allow angle and used with short, lateral strokes to shear away hardened composite after braces remove. And the other end is for scaler designed with pointed tip is used to carefully chip away residual cement from hard to reach areas and also interproximal spaces and around the braces
ADHESIVE REMOVING PLIERS
The Adhesive Removing Plier is used for remove composite material after debonding of orthodontic brackets and attachments from the teeth. The one side of plier comes with ¼” pad one the working ends the other side has a scraper replaceable blade with hex key allowing to remove extra composite material without damaging the tooth.
BAND PUSHER/ ELASTIC REMOVER
Band Pusher and Elastic Remover is a double ended orthodontic instrument. The one side band pusher is use for seating pre-molar and molar band. The groove and textured rectangular tip provides firm grip and avoid slippage and the other side elastic remover is fine round pointed tip is used remover elastomeric ligature from the brackets.
BIRD BEAK PLIER WITH CUTTER
The Bird Beak Plier with cutter is designed for versatile and precision. The cone and the flat pyramid beaks are for creating multi sizes loops. The cutter added at the end of the beaks with tungsten carbide sharp cutting blades can easily cut stainless steel wires.
| WIRE TYPE | MINIMUM | MAXIMUM |
|---|---|---|
| ROUND | .012” (.30mm) | .025” (.64mm) |
| RECTANGULAR | .016” × .016” (.41mm × .41mm) |
.025” × .025” (.56mm × .64mm) |
BRACKET HEIGHT GAUGE LARGE SWIVEL .022
Bracket Height Gauge Standard Swing are specially design for use precise measure, align and position of orthodontic bracket. Precise 45° swivel head on both ends, allowing the practitioner easy access to the posterior/molar regions. The four side typically measures 3.5mm, 4.0mm, 4.5mm, and 5.0mm from the incisal edge of bracket slot .022.
BRACKET HEIGHT GAUGE STANDARD SWIVEL .018
Bracket Height Gauge Standard Swing are specially design for use precise measure, align and position of orthodontic bracket. Precise 45° swivel head on both ends, allowing the practitioner easy access to the posterior/molar regions. The four side typically measures 3.5mm, 4.0mm, 4.5mm, and 5.0mm from the incisal edge of bracket slot .018.