Shop
HOLE PUNCH PLIER 5mm
The Hole Punch Plier 5 mm is design for creating half-moon cutouts precisely. This can help accommodate attachments, buttons, or other orthodontic attachments. The accurate and fixed précised design is to allow 5mm punch on aligners with ease and without adhering to the aligner material.
HOLE PUNCH PLIER 6mm
The Hole Punch Plier 6 mm is design for creating half-moon cutouts precisely. This can help accommodate attachments, buttons, or other orthodontic attachments. The accurate and fixed précised design is to allow 6mm punch on aligners with ease and without adhering to the aligner material.
HOOK CRIMPING PLIER ANGLED
Hook crimping plier is specially design for auxiliary hooks and stops onto archwires. The slit fits over the base of the hook while holding and crimping tightly.
HORIZONTAL PLIER
Horizontal Aligner Plier are designed for accurate correction of a horizontal tooth rotation in the mesial or distal and lingual. The horizontal tips can make accurate vertical indent or notch in the aligner.
INDENT ERASER PLIER
The Indent Eraser Aligner Plier is designed to remove indentation from aligners by other instruments. The précised aligned tips can erase smoothly and restoring the aligner surface. The flat surface of eraser plier may also be used to reduce the thickness of pressure point
LIGHT PLIER WITH GROOVE
The light wire with groove is designed with long cone and pyramid flat beaks used for give very fine and precise loops on light wires up to 0.20” (0.51 mm). The groove at the tips allowing to make duplicate loop and the groove also ensure the firm grip on wires to helping out banding, holding and placing.
| WIRE TYPES | MINIMUM | MAXIMUM |
|---|---|---|
| ROUND | .012” (.30mm) | .020” (.51mm) |
LONG BIRD BEAK PLIER
The Long Bird Beak Plier Is design for adjusting retainers, bending and forming small loops on arch wires also helpful for forming springs in ligature and light orthodontic wires. The tips designed a slightly cone and a pyramid shaped beaks ensure smooth and wider grip and helpful to prevent wire slippage during the orthodontic procedure. The slim and long beaks can easily reach hard to reach areas.
| WIRE TYPES | MINIMUM | MAXIMUM |
|---|---|---|
| ROUND | .012” (.30mm) | .025” (.64mm) |
| RECTANGULAR | .016” × .016” (.41mm × .41mm) |
.022” × .025” (.56mm × .64mm) |
RETENTION POINT DIMPLE PLIER 1mm
The Retention Point Dimple Plier is designed to create tiny rounded dimple in the aligner providing targeted pressure to specific tooth movement and improve aligner retention. The wrench allows adjusting the height of dimple. The ergonomic design ensure comfortable handling while practices.
TEAR DROP PLIER
Tear Drop Aligner Plier is design for create a notch at the gingival margin of aligners anywhere elastic hooks are required to hold the elastic in place as the aligner is seated.
VERTICAL PLIER
Vertical Aligner Plier are designed for accurate correction of a vertical tooth rotation in the mesial or distal and lingual. The vertical tips can make accurate vertical indent or notch in the aligner.
HOOK CRIMPING PLIER STRAIGHT
Hook crimping plier is specially design for auxiliary hooks and stops onto archwires. The slit fits over the base of the hook while holding and crimping tightly.
BAND CRIMPING PLIER
The crimping plier precisely designs to crimp orthodontic bands and crowns to ensure accurate fit.
It is also used for use for placing stops and tubes on archwires. The plier allows orthodontist to effortless crimp & fit band tightly.